Then, use the Left/Right Arrows to select “Delete” and delete the partition. ![]() ![]() Step 1: Highlight the primary partition on the USB device with the Up/Down Arrows on the keyboard. To do this, follow the step-by-step instructions below. Inside of the Cfdisk partition editor, you must delete all partitions on the flash drive. If you need help finding the label of the drive, follow this guide. If you have other devices connected to the Raspberry Pi in addition to the USB flash drive, it may not show up as /dev/sda, but as /dev/sdb, /dev/sdc, or even /dev/sdd. Note: the USB flash drive only has the /dev/sda label if it is the only USB storage device connected. lsblkĪfter finding the device label for the USB flash drive, open it up in the Cfdisk partitioning tool with the command below. Locate the USB drive’s label to confirm that the Pi is reading the device. The output of the lsblk command will show you all storage devices connected to the Pi. Inside of the terminal, run the lsblk command in the terminal. Note: if your Raspberry Pi device is a server, log in over SSH rather than accessing a terminal on it directly. ![]() Before removing the SWAP space from the SD card and placing it on to the USB flash drive, you must format the USB to the correct format (EXT4.) To start the process, plug in any USB flash drive into the USB port and open up a terminal.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |